• 2x PT Sill plate w/sill seal
• 2x6 KD plates & studs 16” O.C.
• 2x10 KD door & window headers
• OSB wall sheathing and TYPAR

SUBFLOOR MATERIALS:

• 2x PT Sill plate w/sill seal
• Lally columns or 6x6 PT subfloor support posts
• 2x KD Double boxsill
• 2x12 KD Triple subfloor girder beam & 2x10 KD Floor joists
• Metal joist bridging and hangers
• “Advantech” T&G subfloor sheathing w/construction adhesive

EXTERIOR WALL MATERIALS:

• Western Red Cedar Or Kiln-dried Pine pre-cut & numbered wall and gable logs
• Log siding for skirt board, daylight walls, dormers & garages
• False log corners at skirt board
• Pre-cut and routered door and window bucks
• 2x Radius edged pine exterior door and window trim
• Caulk, foam gasket, pre-cut hardwood dovetail splines and “Log Hogs”
• 6x6 FIR posts, strongbacks & corner posts

INTERIOR FRAMING:

• 2x6 KD Bearing wall framing & studs 16” O.C.
• 2x KD Non-load bearing wall plates, studs & headers
• 1x6 T&G Scandinavian-Pine for wall sheathing, soffits and dormers
• R-19 Fiberglass insulation @ exterior framed walls (dormers, boxsill & daylight)

INTERIOR FINISHES:

• 6-panel Interior doors w/hardware, pine bi-fold doors w/hardware
• 1x Pine interior door, window & baseboard trim
• Closet rods & brackets (shelving not included)

INTERIOR STAIRS & RAILING SYSTEMS:

• 2x12 KD stair stringers and treads (basement)
• 4x12 FIR stair stringers and treads (2nd floor)
• ۬۬6 Hand rail w/brackets
• 4x6 FIR Rails & Posts w/2x2 balusters

• Andersen 400 Series windows w/screens (specify hardware)
• Andersen patio doors w/screens (bright brass hardware)
• Therma-tru fiberglass entry doors (bright brass hardware)

LOFT MATERIALS:

• 6x12 FIR loft carry beams (if applicable)
• 4x8 Loft joists
• 2x6 T&G Spruce decking

ROOF MATERIALS (MAIN & PORCH):

• 4x12 FIR Ridge beams, 4x8 FIR Rafters
• Collar ties and blocking (as required)
• R-32 Rigid insulation w/2x insulation stop
• 5/8” OSB sheathing
• 1x6 Scandinavian-Pine T&G ceiling and soffit sheathing w/2 layers-15#
• felt paper, ice/water shield (as required) and 30yr. architectural shingles
• Drip edge, flashing, soffit and ridge vent
• 4x8 FIR Porch rafters, carry beams & 4x6 porch posts
• 2x6 T&G Spruce decking @ porch roof

DECKS:

• 6x6 PT Posts (6’)
• 2x PT Deck Framing
• Copper back flashing, bolts & washers
• 4x6 FIR Rails & Posts w/2x2 balusters
• 5/4 Cedar Decking

GARAGE: (if applicable)

• 2x4 KD Framing
• 7/16 OSB Sheathing (walls)
• 5/8 OSB Sheathing (roof)
• Standard Factory Trusses

MISCELLANEOUS:

• “Sikkens” Exterior Stain
• “Symphony” Interior Finish
• Nail Allowance ($300 minimum or $.30/sq.ft.)
• Blueprints & Construction Manual

• 2x PT Sill plate w/sill seal
• 2x6 KD plates & studs 16” O.C.
• 2x10 KD door & window headers
• OSB wall sheathing and TYPAR

SUBFLOOR MATERIALS:

• 2x PT Sill plate w/sill seal
• Lally columns or 6x6 PT subfloor support posts
• 2x KD Double boxsill
• 2x12 KD Triple subfloor girder beam & 2x10 KD Floor joists
• Metal joist bridging and hangers
• “Advantech” T&G subfloor sheathing w/ construction adhesive

EXTERIOR WALL MATERIALS:

• Western Red Cedar or Kiln-dried Pine pre-cut & numbered wall and gable logs
• Log siding for skirt board, daylight walls, dormers & garages
• False log corners at skirt board
• Pre-cut and routered door and window bucks
• 2x Radius edged pine exterior door and window trim
• Caulk, foam gasket, pre-cut hardwood dovetail splines and “Log Hogs”
• 6x6 FIR posts, strongbacks & corner posts

INTERIOR FRAMING:

• 2x6 KD Bearing wall framing & studs 16” O.C

• Andersen 400 Series windows w/screens (specify hardware)
• Andersen patio doors w/screens (bright brass hardware)
• Therma-tru fiberglass entry doors (bright brass hardware)

LOFT MATERIALS:

• 6x12 FIR loft carry beams (if applicable)
• 4x8 Loft joists
• 2x6 T&G Spruce decking

ROOF MATERIALS (MAIN & PORCH):

• 4x12 FIR Ridge beams, 4x8 FIR Rafters
• Collar ties and blocking (as required)
• R-32 Rigid insulation w/2x insulation stop
• 5/8” OSB sheathing
• 1x6 Scandinavian-Pine T&G ceiling and soffit sheathing w/2 layers-15# felt paper, ice/water shield (as required) and 30yr.
• architectural shingles
• Drip edge, flashing, soffit and ridge vent 4x8 FIR Porch rafters, porch carry beams, 4x6 porch posts
• 2x6 T&G Spruce decking @ porch roof

MISCELLANEOUS:

• “Sikkens” Exterior Stain
• Nail Allowance ($300 min. or $.30/sq.ft.)
• Blueprints & Construction Manual

• Western Red Cedar or Kiln-dried Pine pre-cut & numbered wall and gable logs
• Log siding for skirt board, daylight walls, dormers & garages
• False log corners at skirt board
• Pre-cut and routered door and window bucks
• 2x Radius edged pine exterior door and window trim
• Caulk, foam gasket, pre-cut hardwood dovetail splines
• and “Log Hogs”
• 6x6 FIR posts, strongbacks & corner posts

LOFT MATERIALS:

• 6x12 FIR loft carry beams
• 4x8 Loft joists with hangers

ROOF MATERIALS:

• 4x12 FIR Ridge beams, 4x8 FIR Rafters
• 4x8 FIR Porch rafters, porch carry beams, 4x6 porch
• posts
• Collar ties and blocking (as required)

• 2x PT sill plate w/sill sea
• 2x6 KD plates & studs 16" O.C.
• 2x10 KD door & window headers
• OSB wall sheathing and TYPAR

• 2x PT sill plate w/sill seal
• Lally columns or 6x6 PT sub-floor support posts
• SIP insulated panel band joist
• 2x12 KD Triple sub-floor girder beam & 2x10 KD Floor joists
• Metal joist bridging and hangers
• "Advantech" T&G sub-floor sheathing w/construction adhesive

• R-25 Poly-Iso 4½" structural panel, pre-cut & numbered wall and gable Panels w/Western Red Cedar Or Kiln-dried Pine Siding. (A variety of horizontal or vertical sidings & shakes are available)
• Siding for skirt board, daylight walls, dormers & garages
• Corner boards or False log corners at skirt board
• KD framing for door and window bucks & perimeter plates and nailers.
• Western Red Cedar or Pine exterior door and window trim & fascia
• 6x6 FIR posts & corner posts
• Caulk, foam gasket, Plywood splines, Spray foam

• 2x6 KD bearing wall framing & studs 16" O.C.
• 2x4 KD non-load bearing wall, studs
• 2x KD plates & header
• 1x6 T&G Scandinavian-Pine and/or drywall for wall sheathing, soffits and dormers
• R-19 fiberglass insulation @ exterior framed walls (dormers, boxsill & daylight, if applicable)
• 6-panel interior doors w/hardware, pine bi-fold doors w/hardware
• 1x Pine interior door, window & baseboard trim, closet rods & brackets

• 2x12 KD stair stringers and treads (basement)
• 4x12 Fir stair stringers and treads (2nd floor)
• 1¼x16 hand rail w/brackets
• 4x6 Fir Rails & Posts w/2x2 balusters

• Andersen 400 Series windows w/screens (specify hardware)
• Andersen patio doors 2/screens (bright brass hardware)
• Therma-tru fiberglass entry doors (bright brass hardware)

• 6X12 Fir loft carry beams (if applicable)
• 4x8 loft Joists
• 2x6 T&G Spruce decking

• 4x12 Fir ridge beams. 4x8 Fir rafters
• Collar ties and blocking (as required)
• R-32 SIP Poly-Iso structural 5½" pre-cut & numbered Roof Panel w/2x KD perimeter nailer, ½" plywood splines & spray foam
• 1x6 Scandinavian Pine T&G ceiling and soffit sheathing w/Top Guard water shield, 1x3 strapping & screw down metal roofing
• Soffit and ridge vent
• 4x8 Fir porch rafters, carry beams & 4x6 porch posts
• 2x6 T&G Spruce decking @ porch roof

• 6x6 PT posts (6')
• 2x PT deck framing
• Copper back flashing, bolts & washers
• 4x6 Fir rails & posts w/2x2 balusters
• 5/4 Cedar decking

• 2x4 KD framing
• 7/16 OSB sheathing (walls)
• 5/8 OSB sheating (roof)
• Standard factory trusses

• "Sikkens" exterior stain
• "Symphony" interior stain
• Nail allowance ($300 minimum or $ .30/sq. ft.)
• Blueprints & Construction Manual

• 2x PT sill plate w/sill seal
• 2x6 KD plates & studs 16" O.C.
• 2x10 KD door & window headers
• OSB wall sheathing and TYPAR

• 2x PT sill plate w/sill seal
• Lally columns or 6x6 PT sub-floor support posts
• SIP insulated panel band joist
• 2x12 KD Triple sub-floor girder beam & 2x10 KD floor joists
• Metal joist bridging and hangers
• "Advantech" T&G sub-floor sheathing w/construction adhesive

• R-25 Poly-Iso 4 ½" structural panel pre-cut & numbered wall and gable panels w/ Western Red Cedar or Kiln-dried Pine Siding. (A variety of horizontal or vertical sidings & shakes are available).
• Siding for skirt board, daylight walls, dormers & garages
• Corner boards or false log corners at skirt board
• KD framing for door and window bucks & perimeter plates and nailers.
• Western Red Cedar or Pine exterior door and window trim & fascia
• 6x6 Fir posts & corner posts
• Caulk, foam gasket, plywood splines, spray foam

• 2x6 KD bearing wall framing & studs 16" O.C.

• Andersen 400 Series windows w/screens
• (specify hardware)
• Andersen patio doors w/screens (bright brass
• hardware)
• Therma-tru fiberglass entry doors (bright brass
• hardware)

• 6x12 Fir loft carry beams (if applicable)
• 4x8 loft joists
• 2x6 T&G Spruce decking

• 4x12 Fir ridge beams, 4x8 Fir rafters
• Collar ties and blocking (as required)
• R-32 SIP Poly-Iso Structural 5 ½" pre-cut & numbered
• Roof panel w/ 2x KD perimeter nailer, 1/2" plywood splines & Spray foam.
• 1x6 Scandinavian-Pine T&G ceiling and soffit sheathing w/ Top Guard water shield, 1x3 strapping & screw down metal roofing.
• Soffit and ridge vent
• 4x8 Fir porch rafters, carry beams & 4x6 porch posts
• 2x6 T&G Spruce decking @ porch roof

• "Sikkens" exterior stain
• Nail allowance ($300 min. or $.30/sq.ft.)
• Blueprints & Construction Manual

• R-25 Poly-Iso structural 4 ½" pre-cut & numbered wall and gable panels
• Foam gasket, plywood splines

• 6x12 Fir loft carry beams
• 4x8 loft joists with hangers
• 2x6 T&G Spruce decking

• 4x12 Fir ridge beams, 4x8 Fir rafters
• Collar ties and blocking (as required)
• R-32 SIP Poly-Iso structural 5 ½" pre-cut & numbered roof P\panel w/ 1/2" plywood splines
• 4x8 Fir porch rafters, carry beams & 4x6 porch posts
• 2x6 T&G Spruce decking @ porch roof